Stickmen necklace

[squirmelia]

On Saturday, I 3D printed this stickmen necklace I found on Thingiverse. (Design by skarab: StickMan's Necklace). I actually printed it in white PLA and then painted it black, and added a bit of Sugru where the holes were a bit messed up, to thread the wire through.

Comments

[blue-mai.livejournal.com]

I'm sure this is already on your radar, but - http://arthackathon.co.uk/

[squirmelia.livejournal.com]

I am not sure that I am enough of a hacker/artist or artist/hacker that it wants, but I have signed up anyway and been accepted, so I'm going to give it a go. :)

[blue-mai.livejournal.com]

:)